Having tried and been disappointed with the standard blower camel hair brushes that many use for removing dust from lenses, I decided to pick up a can of compressed gas like they use for blowing the dust out of electronic components and computer keyboards. However, when I read the labels on the different brands, they all stated that they are NOT to be used on camera lenses or mirrors.
I can only assume that would mean you shouldn't use them to blow dust off of your bino lenses as well, but does anyone know why? Is there some chemical in there that eats the lens coatings or puts a film on the lenses? Has anyone found a product like this that is safe for use on lenses?
Any feedback would be appreciated.
Thanks,
Dean
It may be because the air coming from the can gets very cold as it expands, which may damage the lenses or the adhesion of the coatings because of different expansion rates.
When I use one of those cans, frost forms on the nozzle, so there may also be a possibility of little chunks of stuff being squirted on the glass..
The little prepackaged sealed squares soaked in isopropyl alcohol work well for in the field cleaning after you've brushed off any gritty dirt.
I have never used the compressed air cans for cleaning, but I have used filtered shop air from a 60 gal. compressor. I use 2 clean rags and blow lightly through these rags. I did a search on Cloudy Nights and found a thread about cleaning optics. The one post I picked out was done by Brock on here and it located below. I think the people that make these compressed air cans probably put this warning on the can to cover their butt.:-) I use the Zeiss wipes after blowing, without any down pressure, switch to clean one etc. etc. Water proof binoculars. If very bad, warm water in a sink with just a little dish det. in it and rinse under facet and then rinse with distilled water etc.
Steve
"Some have mentioned using compressed air or a lens brush. I prefer the lens brush, because I have to be careful about holding the compressed air can nozzle at the right distance and using only short bursts or the propellant will get on the lens, and it's hard to get off. I tend to use compressed air only when I'm outside and have several bins to clean. I use "Bessler DustGun", which is CFC-free. "